• Slide 1
    Fig. 1 Pre-operative appearance of tooth No. 29. Note the existing restoration has fractured interproximally, leaving an open contact.
  • Slide 2
    Fig. 2 The preparation on tooth No. 29 is verified with Snoop Caries Detector (Pulpdent).
  • Slide 3
    Fig. 3 Tooth No. 29 has been isolated with a rubber dam and Palodent Plus Sectional Matrix.
  • Slide 4
      Fig. 4 After etching with 34 percent phosphoric acid, Prime&Bond Elect is scrubbed into the preparation.
  • Slide 5
      Fig. 5 The first restorative layer is placed using Surefil SDR flow via a compula tip.
  • Slide 1
    Fig. 6 The occlusal layer is completed using TPH Spectra Universal Composite Low Viscosity shade A2.
  • Slide 2
    Fig. 7 The filled preparation of tooth No. 29 after light curing, before removal of the matrix and finishing and polishing.
  • Slide 3
    Fig. 8 Close-up of the Palodent Plus Pin Tweezers being used to easily remove the sectional matrix after composite placement.
  • Slide 4
      Fig. 9 The final restoration on Tooth No. 29.
  • Slide 5
      Fig. 10 Close-up view of caries on the mesial of tooth No. 30.
  • Slide 1
    Fig. 11 Completed preparation for tooth No. 30-MOD. Palodent Plus Wedge Guards are in place to prevent iatrogenic damage to the adjacent teeth.
  • Slide 2
    Fig. 12 Tooth No. 30 has been isolated with a rubber dam and 34 percent phosphoric acid has been applied to the enamel margins.
  • Slide 3
    Fig. 13 Tooth No. 30-MOD is isolated with Palodent Plus Sectional Matrix System.
  • Slide 4
      Fig. 14 The completed restoration on tooth No. 30.